Surface Preparation
All surfaces must be cured, clean, sound, dry and free of all dirt, dust, efflorescence, wax, oil, grease, chalk and any other contamination that would interfere with new coating adhesion. New masonry and mortar must cure for minimum of 30 days at 72°F (22°C) prior to coating application. Level all surface projections and mortar spatters. Remove all soluble salts. Performance will be directly related to the degree of surface preparation.
Recommended Products
| Primer: | OmniPrep Universal Interior/Exterior Primer |
| Finishes: | Permacryl Interior Acrylic Latex Enamel |
| Vantage Plus Interior Latex | |
| Assure Interior Latex Enamel | |
| Zero Plus Interior Zero VOC* Latex |
The products above are commonly recommended for brick. Other Diamond Vogel products may be better suited for your project. Please contact your Diamond Vogel representative for personalized service.
*Zero Plus is designated zero VOC (volatile organic compounds) based on EPA Method 24. All zero VOC paints emit chemicals. This paint emits chemicals during and for approximately two weeks after painting but at much lower levels than conventional latex paints. Sensitive groups should minimize exposure during painting and for 24 hours after. “Zero VOC” does not mean “asthma/allergy friendly.”